MAXIMUM LIGHTNESS: thanks to the innovative raw materials wrought by numerical control machines.

MAXIMUM SAFETY: the plug obtained from a single block of special plastic with low friction coefficient allows the motorbike to stop gradually during the fall reducing the risk of a roll over. All the fixing bolts are made of high-tensile steel.

MAXIMUM SAVING: in case of fall You will only need to replace the plastic plug. With a very low expense Your frame slider will be as good as new.

INNOVATIVE AESTHETIC QUALITY: we have studied a new design that matches the frame sliders with the line of the new motorbikes, both sports and naked ones. In addition each aluminium part has been treated with an anodizing process that prevents the attack of atmospheric agents, preserving them forever as if they were new. The plug has been screen printed by laser.

SCREW PREVENTION SYSTEM: the only ones that have a system which prevents the loss of the plug during the driving.

MAXIMUM DISASSEMBLY PRACTICALNESS: it is sufficient to unscrew the plug with Your bare hands, without using utensils.

FRAME SLIDERS DEFENDER: THE TOP!


ASSEMBLING INSTRUCTIONS:
- the cardboard in the box indicates with the L letter the left slider (shorter) and with the R letter the right slider (longer),
- remove both left and right side of the fairing,
- on the right side loosen up the little bolt that holds the frame like a clamp around the bolt that fastens the engine, then remove the principal bolt inside the frame,
- unscrew with your hands the plug of the longer aluminium slider, insert it in the frame and fix it to the engine with the help of a 10mm allen key,
- tighten the little bolt that holds the frame around the slider,
- take off the bolt that fastens the engine to the frame on left side,
- unscrew the derlyn plug and fix the slider on the frame with the new bolt that you find on the kit by using a 10mm allen key, (ATTENTION: we suggest to tighten all the bolts as advised by the manufacturer )
- drill the fairing where the the sliders will be placed by using a circular saw blade, (practice two holes of diameter 38mm at least),
- put back the fairing and screw with vim the two plugs on the sliders.